Debrick router router via ssh terminal flash commands

DEBRICK ROUTER ROUTER VIA SSH TERMINAL FLASH COMMANDS SOFTWARE
DEBRICK ROUTER ROUTER VIA SSH TERMINAL FLASH COMMANDS PASSWORD
DEBRICK ROUTER ROUTER VIA SSH TERMINAL FLASH COMMANDS PC

Part 2: Display Device Information Step 1: Retrieve hardware and software information from the network devices. Configure the default gateway according to the Addressing Table.Configure the IP address for the SVI for VLAN 1 according to the Addressing Table and activate the interface.Assign a device name to the switch according to the Addressing Table.Console into the switch and enable privileged EXEC mode.Note : Most of the commands on the switch are similar to the commands on the router in this step. The default settings for the 2960 switch will automatically enable the interfaces that are connected to devices. The router is routing the ping traffic across the two subnets. Save the running configuration to the startup configuration file.

Configure the IP addresses according to the Addressing Table and activate both Ethernet interfaces on the router.

Create a banner that warns anyone accessing the device that unauthorized access is prohibited.

DEBRICK ROUTER ROUTER VIA SSH TERMINAL FLASH COMMANDS PASSWORD

Assign cisco as the console password and enable login.

Assign class as the privileged EXEC encrypted password.

Assign a device name to the router according to the Addressing Table.

( Hint: Use console cable and terminal on a PC)

Console into the router and enable privileged EXEC mode.

The router interfaces (default gateways) have not been configured yet so the traffic is not being routed between subnets.

Ping PC-B from a command prompt window on PC-A.

Configure the IP address, subnet mask, and default gateway settings on PC-B.

Configure the IP address, subnet mask, and default gateway settings on PC-A.

DEBRICK ROUTER ROUTER VIA SSH TERMINAL FLASH COMMANDS PC

Step 2: Assign static IP information to the PC interfaces. You will connect them using the correct cables between the devices as listed below: The devices are already deployed in the workspace.

Refer to the Addressing Table at the beginning of this activity for device names and address information. In Part 1, you will set up the network topology and configure basic settings, such as the interface IP addresses, device access, and passwords. Instructions Part 1: Configure Devices and Verify Connectivity You will also access the router remotely via SSH. After the configurations have been saved, you will verify your configurations by testing for network connectivity.ДЄfter the devices have been configured and network connectivity has been verified, you will use IOS commands to retrieve information from the devices to answer questions about your network equipment. In this lab, you will cable the equipment and configure the devices to match the Addressing Table. Create an SSH user and configure VTY lines for SSH-only access.Set the IP domain name and generate secure keys.Part 3: Secure Remote Access to the Router Display a summary list of the interfaces on the router and switch.Display interface information on the router.Interpret the output from the routing table.Retrieve hardware and software information from the network devices.Assign static IP information to the PC interfaces.Part 1: Configure Devices and Verify Connectivity

Debrick router router via ssh terminal flash commands